What NOT To Do When It Comes To The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a bit but it's still appealing. It's not the most luxurious car in its class, but it's an enjoyable and comfortable driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous, the following tips should assist.
Water Damage
If you accidentally drop your key fob into a puddle, or if it is soaked while kayaking, canoeing, rafting or canyoning the fob is most likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag whenever you're going outdoors or doing activities that require the fob to be exposed to high levels of water.
It's also important to make sure that the fob has dried out prior to opening it up and then use it again. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid), this is another indicator that it is submerged.
A circuit that is wet can cause the battery's charge to be drained or even explode. If you're able to fish your key fob 308 out of whatever body of water it got stuck in it, flip the button side down and shake it out as much water as you can before opening the case. When you've opened it, remove the battery, and then clean the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery or receiver module issues signal interference or a faulty chip. If none of the above is the reason it is possible to reset the system by disconnecting 12 Volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars come with remote start systems which allows drivers to start their car from the distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely helpful, especially during cold winter months. However, sometimes the remote start system stops operating due to a range of reasons, like the battery of a coin that is dead.
A coin-shaped battery that is located inside the key fob will last a time of between two and four years, depending on how often it is used and the location where it was purchased. The date of use is displayed on the packaging or mentioned in the user manual.
If the key fob stops working after being exposed pure tapwater, you need to remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If you expose it to salty or soapy water, the chip could be fried and you will have to replace the key fob completely.
If you're not sure the battery is faulty You can test its voltage using a multimeter that is set to the car's voltage range and connected to the plus and minus terminals. The voltage should read approximately 12 to 13 volts, but if it's lower, the battery needs to be replaced. You can also attempt to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has been afflicted with a fault. It's the part that transmits a signal to the car when your key fob is activated, it also acts as an immobiliser. It also stops it from starting unless the correct key is present.
This can be due to a number of factors, including water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for instance, the electronic chip inside may be damaged. In this instance, you'll have to take it off and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the problem persists it is recommended that you visit an area Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the issue and fix it.
Losing peugeot 107 remote key replacement to your car can be an extremely stressful experience. However, a trained auto locksmith can address the issue in just a few minutes. They can program your car and cut a fresh, working key for you. Click here to find a local locksmith near you.
Electronic chip that is malfunctioning
The chip in the Peugeot 308 key fob plays a crucial function in the remote control system. If it gets damaged, your car might not start or receive a message that reads "anti-theft active". In this case, the only solution is to replace the key. Auto locksmiths who are professionals are able to provide the service in the shortest time.
The chip in your Peugeot 308's key fob could be damaged due to a variety of reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, clean it right away. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. Then, you need to allow the battery to dry completely.
Radio interference can cause a key fob to stop working. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects around the vehicle. It is recommended to see a Peugeot dealer if you encounter this issue.
The Peugeot 207/308 key fob is very delicate and requires extra attention. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as you can. You can reset the onboard computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, then the positive.